Some of our clients will use signal repeaters to get a further control range when they need to apply our DMX products in some huge spots.

Please check the following steps to install and use the RF repeater.

• Step1.  Get the DMX transmitter/RF handheld controller ready.

• Step2. Using the cable to connect the repeater with the DMX transmitter/RF handheld and console or PC.

• Step3. Power ON the DMX transmitter/RF handheld controller and the repeater.

Notice:

This device should be installed and operated with a minimum distance of 200 cm between the radiator & your body.

The Products generate, use, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on.

Your device generates, uses, and can radiate radio frequency (RF) energy and, if not used in accordance with its instructions, may cause interference to radio communications and electronic equipment.

In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose of or recycle the device in accordance with your local laws and regulations.